Files
Editable source.
Native EasyEDA / KiCad project files. The design is yours. No lock-in, no licensing puzzle.
Every project moves through the same disciplined path. No hand-offs to junior engineers. No "we'll figure it out in layout." Every decision is owned, end-to-end, by one person who's done it 250 times before.
A clean schematic is the contract between idea and copper. Component selection, signal flow, power trees, decoupling strategy — captured precisely before a single trace is drawn.
Parts are picked for availability, lifecycle, and second-source. The schematic that ships is the schematic that can keep shipping in twelve months.
DFM concerns surface at the schematic stage, not after the first prototype run. Saves weeks. Saves money. Saves hairline.
Layouts tuned for cost, performance, and yield. Power routed wide, ground planes solid, signals isolated where it matters. No floating pours, no stubs left in.
Crosstalk budgets. Return-path integrity. Antenna keep-outs. The radio works because the layout already agreed it would.
Thermal vias under hot pads. Copper pours sized to spread heat. The board runs cool because it was drawn to.
Firmware flashing, bring-up, and real-world validation so the board behaves the way the schematic promised. If it doesn't, it doesn't ship.
Real silicon on a real bench. Power-up sequencing, current draw, signal integrity, thermal soak — measured, logged, signed off.
Findings flow back into schematic and layout. The next rev isn't a redesign — it's a refinement, with the lessons baked in.
From first message to finished hardware on your bench.
You describe the goal, constraints, BOM ideas, and any sketches. I scope, quote, and confirm timelines.
Captured in EasyEDA Pro or KiCad. Reviewed together before a single track is drawn.
Stack-up, placement, routing, pour, DRC. Iterated until the board is yours, not just mine.
Gerbers, drill files, BOM, CPL — everything a fab and assembler need, packaged clean.
Flash, power, probe, validate. You get the board, the data, and the source files.
Everything you need to manufacture, assemble, and own the design forever.
Native EasyEDA / KiCad project files. The design is yours. No lock-in, no licensing puzzle.
Gerber X2, drill files, NC routes, IPC-356 netlists, board outline DXF — everything a manufacturer expects, formatted clean.
Bill of Materials with manufacturer part numbers, lifecycle status, and second sources. CPL pick-and-place ready for JLCPCB / PCBWay / your assembler.
Stack-up, impedance targets, thermal calcs, test results. The reasoning behind every non-obvious decision, written down.